What problems should be paid attention to during the operation of the laser cutting machine

The laser cutting machine brings a lot of convenience to everyone's work. However, in actual production, some people ignore some precautions when operating the laser cutting machine, which leads to shortened service life and malfunctions during use. More serious, there may be production accidents. So what are the problems that should be paid attention to during the operation of the laser cutting machine? 　　1. Observe the safety operating regulations of laser cutting and start the laser strictly in accordance with the laser startup procedure; the operator must be trained, familiar with the equipment structure and performance, and master the operating system. Knowledge; wear labor protection equipment as required, and must wear protective glasses that meet the requirements near the laser beam; do not process a material before it is clear whether it can be irradiated or heated by laser, so as to avoid the potential of smoke and vapor Danger; 　　2. When the equipment is started, the operator shall not leave the post or be entrusted without authorization. If it is necessary to leave, stop or cut off the power switch; keep the fire extinguisher within easy reach; turn off the laser or when not processing Shutter; do not place paper, cloth or other flammable materials near the unprotected laser beam; if an abnormality is found during the processing, the machine should be stopped immediately, and the fault should be eliminated or reported to the supervisor in time; 　　3, keep the laser, bed and The surrounding site is clean, orderly, and oil-free. Workpieces, plates, and waste are stacked according to regulations; when using gas cylinders, avoid crushing the welding wires to avoid electric leakage accidents; the use and transportation of gas cylinders should follow the gas cylinder supervision regulations; prohibition The gas cylinder is exposed to the sun or close to a heat source; when opening the bottle valve, the operator must stand on the side of the bottle mouth; 　　4. Observe high-pressure safety regulations during maintenance; every 40 hours of operation or weekly maintenance, every 1000 hours of operation or every time During the six-month maintenance, follow the regulations and procedures; 　　 5. After starting the machine, the machine should be manually started in the X and Y directions at low speeds to check whether there are any abnormalities; after the new workpiece program is input, test run first and check it. Operation status; When working, pay attention to the operation of the machine tool to avoid accidents caused by the cutting machine going out of the effective travel range or two collisions; 　　 Wuhan Gaoneng Laser Equipment Manufacturing Co., Ltd. is a high-tech company integrating Ru0026D, production and sales of professional laser complete sets of equipment Technology enterprises. Not only successfully developed laser equipment with advanced technology, but also used self-support import and export rights to promote products to more than forty global products including Hong Kong, South Korea, Vietnam, Malaysia, Thailand, Australia, the United States, Japan, Germany, the Netherlands, Jordan, etc. nation.