Thirteen points for the safe operation of fiber laser cutting machine

Safety in production is something that every enterprise has been emphasizing in the production process. Regardless of the industry, safe production is the top priority in production activities. As the third-generation laser cutting equipment, the fiber laser cutting machine is more and more widely used at present, so it has to talk about how to operate safely and bring greater benefits to the enterprise.　　 So after summarizing, if you want to operate the fiber laser cutting machine safely, avoid safety accidents, and improve work efficiency, we need to pay attention to the following 13 points: 　　 1. Observe the safety operation rules of fiber laser cutting machine. Start the laser strictly in accordance with the laser startup procedure.　　2. The operator must be trained to be familiar with the structure and performance of the equipment, and to master the relevant knowledge of the operating system.　　3. Wear labor protection equipment in accordance with the regulations, and wear protective glasses that meet the regulations near the laser beam.　　4. Do not process a material before it is clear whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam.　　5. When the equipment is started, the operator is not allowed to leave the post or be taken care of without authorization. If it is really necessary to leave, the operator should stop the machine or cut off the power switch.　　6. u200bu200bKeep the fire extinguisher within easy reach; turn off the laser or shutter when not processing; do not place paper, cloth or other flammable materials near the unprotected laser beam.　　7. When an abnormality is found during the processing, the machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor in time.　　 8. Keep the laser, the bed and the surrounding area clean, orderly, and free of oil pollution. Workpieces, plates, and waste materials are stacked as required.　　 9. When using gas cylinders, avoid crushing the welding wires to avoid leakage accidents. The use and transportation of gas cylinders should comply with gas cylinder supervision regulations. It is forbidden to explode gas cylinders in the sun or close to heat sources. When opening the bottle valve, the operator must stand on the side of the bottle mouth.　　10. Observe high-voltage safety regulations during maintenance. Every 40 hours of operation or weekly maintenance, every 1,000 hours of operation or every six months of maintenance shall be carried out in accordance with regulations and procedures.　　11. After starting the machine, the machine tool should be manually started in the X and Y directions at low speed, and check whether there is any abnormality.　　12. After inputting the new part program, test run it first and check its operation.　　 13. When working, pay attention to the operation of the machine tool to avoid accidents caused by the fiber laser cutting machine going out of the effective stroke range or two collisions.　　 Wuhan Gaoneng Laser Equipment Manufacturing Co., Ltd. is a high-tech enterprise integrating Ru0026D, production and sales of professional laser complete sets of equipment. Not only successfully developed laser equipment with advanced technology, but also used self-support import and export rights to promote products to more than 40 global markets including Hong Kong, South Korea, Vietnam, Malaysia, Thailand, Australia, the United States, Japan, Germany, the Netherlands, Jordan, etc. nation.