Solutions to errors in laser cutting equipment processing

The error in the processing size is a failure that is often encountered when using a fiber laser cutting machine for processing. This failure not only affects the production efficiency, but also increases the production cost. The following is a simple analysis of the cause of this failure.　　 1. The signal line is abnormal. The signal line needs to be replaced at this time.　　 2. The equipment and the computer are poorly grounded. At this time, the equipment and the computer need to be well grounded.　　 3. The computer is not operating normally. At this time, the computer needs to be repaired or replaced.　　 4. The computer operating system malfunctions or is infected with a virus. You need to reinstall the operating system or perform a virus scan.　　 5. The application software is abnormal. At this time, you need to reinstall the software and the driver software of the motion control card.　　 6. The power supply is unstable or disturbed by signals. At this time, it is necessary to install a voltage stabilizer or eliminate interference signals.　　7. The processing program is not written correctly. At this time, the processing program needs to be checked and repaired.　　 8. The processing parameter setting is incorrect. To reset the correct processing parameters. Wuhan High Energy Laser has been committed to the research and development and sales of metal laser cutting machines for 13 years. Continuously undergoing inspections by customers in the sheet metal industry. Production is based on quality, and sales are based on reputation. Continuously provide perfect metal laser cutting machine solutions for domestic and overseas enterprises and small and medium-sized enterprises: http://www.gnlaser.com/?fpage/c000345|000400