Solution to abnormal reset of laser cutting machine
Laser cutting machine is a common processing equipment in modern times. There will always be some headaches in the process of use, especially the abnormal reset of the laser cutting machine. This is also a problem that everyone is more concerned about. Below I will briefly introduce the solution to the abnormal reset of the laser cutting machine. 1. Check whether the sensor is dirty, poorly connected or damaged (wipe the dust on the sensor or replace it); 2. Check whether the flexible conductive belt data cable is poorly connected or damaged (trim the data cable and re-plug or replace the data cable); 3. Check whether the ground wire is reliable or the high-voltage wire is damaged (re-ground or replace the high-voltage wire); 4. The motor wire is in poor contact. Missing engraving of the laser cutting machine, incorrect initialization, data has been sent (corrected); the order of operation is reversed (re-enter); electrostatic interference (check whether the ground wire is off); the cleaning hook is misplaced and not closed, check whether the software parameter settings are correct ( Reset); the computer system is faulty (reinstall the operating system and software); check whether the left and right belts are the same or whether the rear belt is too loose (the belt is tightened); check whether the belt or the synchronization wheel is slipping or the teeth are jumping (tighten the synchronization wheel or Belt); Check whether the beam is parallel (re-adjust the left and right belts). Wuhan Gaoneng Laser Equipment Manufacturing Co., Ltd. is a high-tech enterprise integrating Ru0026D, production and sales of professional laser complete equipment. Not only successfully developed laser equipment with advanced technology, but also used self-support import and export rights to promote products to more than forty global products including Hong Kong, South Korea, Vietnam, Malaysia, Thailand, Australia, the United States, Japan, Germany, the Netherlands, Jordan, etc. nation.