Safe power-on operation of laser cutting machine

Safe power-on operation is very important for the operation steps of laser cutting machine. So what is the safe power-on operation of laser cutting machine? Compared with many enterprise laser cutting machine operators, they are more aware of this problem. Interest, let’s give you a brief analysis below.　　 The power-on operation of the laser cutting machine can be operated to fully energize each part at one time, or to energize part of the workpiece, and then perform a total power supply test. Partial power supply is relatively safe, but it lasts for a long time. After powering on, check whether there is an alarm fault, and then manually start each component one after another. Before starting, check whether the safety device is working, whether it can work normally, and can reach the rated working index. In short, you must roughly check whether the important parts of the machine work and function are normal and complete according to the machine tool manual. All the links can be operated and moved. Then adjust the level of the CNC machine tool, roughly adjust the geometric accuracy of the machine tool, then adjust the relative position of each assembly part and the main machine, pour the main machine and the anchor bolts of each accessory with quick-drying cement, and fill each reserved hole flat, etc. The cement is completely dry. When powering on for a test run, make sure that the CNC system has been confirmed without any alarm, and be prepared for the emergency button to cut off the power supply.　　 During operation, check the operation of each axis of the laser cutting machine tool. It is necessary to continuously feed each axis by hand, and check whether the movement direction of the machine tool parts is correct through the digital display. Then check whether the moving distance of each axis is consistent with the moving command, and timely feedback if there is a non-conforming parameter.　　 It is also possible to use manual feed to move the axes at low speed and make them touch the overtravel switch. This is to check whether the overtravel limit is valid and whether the CNC system issues an alarm when overtravel. At the end, you need to do a return to the reference point. The reference point of the CNC cutting machine is for the reference position of the machine tool processing program in the future, so it is necessary to check whether there is a reference point function and whether the position of the reference point is the same every time.　　 Wuhan Gaoneng Laser Equipment Manufacturing Co., Ltd. is a high-tech enterprise integrating Ru0026D, production and sales of professional laser complete sets of equipment. Not only successfully developed laser equipment with advanced technology, but also used self-support import and export rights to promote products to more than forty global products including Hong Kong, South Korea, Vietnam, Malaysia, Thailand, Australia, the United States, Japan, Germany, the Netherlands, Jordan, etc. nation.