Introduction to the maintenance method of the air compressor of the metal laser cutting machine
The air compressor of the metal laser cutting machine is one of the very important components. The maintenance of this important component has always been a problem that many companies are more concerned about, because once a failure occurs, it will affect the normal production work of the company. Bring irreparable economic losses. For the maintenance of the metal laser cutting machine air compressor, the following 10 points should be paid attention to in general: 1, oil filter. New parts should be replaced every 2000 hours. 2, oil drain valve. Moisture and dirt are discharged every 2000 hours. 3, safety valve. Every 4000 hours check whether its movements are sensitive. 4. Motor maintenance. Perform maintenance according to the motor operating instructions. 5. Oil-steam separator. New parts need to be replaced every 4000 hours. 6. Minimum pressure valve. Clean it every 4000 hours and check whether the opening pressure is normal. 7. Compressor lubricant. It is necessary to check whether the lubricating oil is sufficient every 1000 hours, and replace the new oil every 4000 hours. 8. Transmission belt. Adjust the tightness every 2000 hours, check the wear and tear every 4000 hours, and decide whether to replace it according to the wear and tear. 9. Inlet valve seals. The air compressor of the laser cutting machine should be checked every 4000 hours of operation, and the sealing ring should be replaced if necessary. 10. Air filter element. Under normal circumstances, the dust and impurities on the surface of the air filter element should be removed every 500 hours, and check whether it needs to be replaced every 2000 hours. The inspection or replacement cycle can be extended or shortened according to the dust content. Wuhan Gaoneng Laser Equipment Manufacturing Co., Ltd. is a high-tech enterprise integrating Ru0026D, production and sales of professional laser complete sets of equipment. Not only successfully developed laser equipment with advanced technology, but also used self-support import and export rights to promote products to more than forty global products including Hong Kong, South Korea, Vietnam, Malaysia, Thailand, Australia, the United States, Japan, Germany, the Netherlands, Jordan, etc. nation.