How to deal with the problem of abnormal reset of laser cutting machine

It is very normal for the machine to have some problems during work, and the same is true for the laser cutting machine. The abnormal reset is one of the more annoying problems that everyone encounters. So how to deal with the problem of abnormal reset of this laser cutting machine? Let's take a look at it below.　　 There are many reasons for the abnormal reset of the laser cutting machine. Whether the left and right belts are the same or whether the rear belt is too loose; whether the belt or synchronous wheel is slipping or jumping teeth; whether the beam is parallel or not can all cause such problems. For specific solutions, we can start from the following points: 　　1, check whether the sensor is dirty, poorly contacted or damaged (wipe the dust on the sensor or replace); 　　2, check whether the flexible conductive belt data cable is in poor contact or Damaged (trimming the data line and plugging in again or replacing the data line); 　　3, check whether the ground wire contact is reliable or whether the high-voltage wire is damaged (re-ground or replace the high-voltage wire); 　　4, the motor wire is in poor contact.　　 Wuhan Gaoneng Laser Equipment Manufacturing Co., Ltd. is a high-tech enterprise integrating Ru0026D, production and sales of professional laser complete sets of equipment. Not only successfully developed laser equipment with advanced technology, but also used self-support import and export rights to promote products to more than forty global products including Hong Kong, South Korea, Vietnam, Malaysia, Thailand, Australia, the United States, Japan, Germany, the Netherlands, Jordan, etc. The country has an advantage in the international market in the same industry.