Four-point operation laser cutting machine needs to pay attention to the details

The operation of the laser cutting machine is not without risk at all. There are certain risks when operating any machine. This is why you need to be careful at work. Then what details are needed when operating the laser cutting machine What does the operator pay attention to? 　　 First of all, the operation of the laser cutting machine needs to comply with the general safety operation regulations of the cutting machine. Start the laser strictly in accordance with the laser startup procedure. Operators must be trained to be familiar with the structure and performance of the equipment, and to master the knowledge of the operating system. Wear labor protection equipment according to the regulations, and you must wear protective glasses that meet the regulations near the laser beam.　　Secondly, when the equipment is started, the operator shall not leave the post or be entrusted without authorization. If it is necessary to leave, the operator should stop the machine or cut off the power switch. Do not process a material before it is clear whether it can be irradiated or heated by laser, so as to avoid the potential hazards of smoke and vapor. Keep the fire extinguisher within easy reach; turn off the laser or shutter when not working; do not place paper, cloth or other flammable materials near the unprotected laser beam.　　 Once again, when an abnormality is found during the processing, the machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor in time. Keep the laser, the bed and the surrounding area clean, orderly, and free of oil pollution, and stack the workpieces, plates, and waste materials in accordance with the regulations. When using gas cylinders, avoid crushing the welding wires to avoid leakage accidents. The use and transportation of gas cylinders should comply with gas cylinder supervision regulations. It is forbidden to explode the gas cylinder in the sun or close to a heat source. When opening the bottle valve, the operator must stand on the side of the bottle mouth.　　Finally, follow the high voltage safety regulations during maintenance. Every 40 hours of operation or weekly maintenance, every 1,000 hours of operation or every six months of maintenance shall be carried out in accordance with regulations and procedures.　　 Wuhan Gaoneng Laser Equipment Manufacturing Co., Ltd. is a high-tech enterprise integrating Ru0026D, production and sales of professional laser complete sets of equipment. Not only successfully developed laser equipment with advanced technology, but also used self-support import and export rights to promote products to more than forty global products including Hong Kong, South Korea, Vietnam, Malaysia, Thailand, Australia, the United States, Japan, Germany, the Netherlands, Jordan, etc. country.